DODGE RAM FORUM banner

1 - 3 of 3 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter #1
hey guys. i had to put my truck into 4Hi last weekend and it worked just fine, but this week whenever i tried to put it in all it does is just blink on the dash. I use my 4 wheel drive alot so i really need a solution! thanks guys. any help is needed
 

·
Registered
Joined
·
12 Posts
I had the same problem with my truck, it would just blink and not lock in after a few seconds like usual. I was trying a 100 different things, and neutral was my solution. I shifted into neutral(on the tree, not the button by the 4WD dial) and ithasn't happened since. I hope its the same situation for you, good luck
 

·
Registered
Joined
·
717 Posts
Try putting it in and out of R a few times slowly, giving it time to "work". I've had sucess with this trick on a lot of 4X4 trucks getting in and out of 4WD. U can also try putting it in 4 low too.
 
1 - 3 of 3 Posts
Top