DODGE RAM FORUM banner
1 - 7 of 7 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter · #1 ·
Looking at putting a system into my 2012 Ram 1500 Big Horn Crew Cab without Alpine system.

Kenwood DDX 419 deck

Kenwood 5 channel amp

Door speakers and single 12" in Fox Box

My question is: do i need a radio interface like the c2r-chy4 (is this the correct one?) -there are 2 audio shops in town and 1 said i need it and the other said i didn't....just looking to clarify this. I apolagise if this has been asked before, thank you!
 

·
Registered
Joined
·
611 Posts
I'd use one. You dont _have_ to have it but it saves hacking the factory wiring. It will give you the remote turn on etc and its plug and play. Do you have factory steering wheel controls?
 

·
Registered
Joined
·
27 Posts
Discussion Starter · #3 ·
Yes i have the factory steering wheel controls. In my previous car (2001 Chrysler 300m) i bought a module that adapted the steering wheel controls with my kenwood single din deck. This should work, also, rtkman what did you pay for the c2r-chy4 being that you are Canadian? Thanks
 

·
Registered
Joined
·
611 Posts
I bought my stuff at Sonic Electronics in the states. It was cheaper to buy it there and ship than to buy it here. ( I bought a nav unit too) I used teh SWI-RC for my steering wheel controls and it just plugs into the C2R-CHY4.

PAC C2R-CHY4 (C2R-CHY4v1): 1 @ $79.99
PAC SWI-RC: 1 @ $52.99
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top