DODGE RAM FORUM banner

1 - 5 of 5 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter · #1 · (Edited)
Well i backed into a little car with my ram 1500 and i happened to just put an exhaust on no less than a month ago. It bent the passenger side exhaust a few inches down.

What can i do to fix this? I am probably going to have to end up taking it to a shop and get them to unbend it but would just heating it with a torch and bending it be alright since it isn't bent a whole lot?

What can i do here?
 

·
Registered
Joined
·
1,280 Posts
If its just bent down you can use a crow bar and bend it back into place. Ive been gulty of having it do that after I slid my car into a ditch.
 

·
Registered
Joined
·
34 Posts
Discussion Starter · #3 ·
We already tried to bend it back up but that thing isn't moving. I been told it is bent in the middle, not the far end.
 

·
Registered
Joined
·
247 Posts
get a map gas set up and heat the area of the pipe till its red hot all the way around and a few pry bars. if you lived in ct i could show you how to do this at the shop
 

·
Registered
Joined
·
34 Posts
Discussion Starter · #5 ·
Alright, thanks for the idea. I'm taking it tonight to see what the guy that put it on can do and how much it would cost. I'll let him know about this.
 
1 - 5 of 5 Posts
Top