1 - 2 of 2 Posts

· Registered
3 Posts
Discussion Starter · #1 · (Edited)
I have a 98 ram 1500 5.9 l 4wd . I having been having a on and off problem where it the engine starts but wont idle. None of the gages are working. I have a scanner (blue driver) but no codes show up

Now it runs but none of the gages work and the security, air bag, abs, and fuel lights are . I get live data capure on scanner when I drive it .

I'm looking at the CCD, any help?

I have run the check test on the console and gages and lights work finei get codes 900,920,940,950, and 999 that indicate a problem with the CCD Bus problems

sometimes every thing works OK , gages work, no lights or 900 codes?
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.