DODGE RAM FORUM banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hey there, I'm not sure if this is the right place to post this but can I get any input from someone who wants to/has done a Cummins swap from a 5.2 magnum 2wd auto to a 5.9 Cummins 4x4 manual? It's a project yes and I already know it's WAAAAAY easier and cheaper to just buy a diesel 4x4 but I need a project and I wanna learn. I figure I'll have to strengthen the frame, fabricate new engine mounts, SFA install and fabricate mounts, transfer case install, rear axle/gear upgrade, all new front end components, heavier duty springs, new ecm, exhaust, etc. any input is greatly appreciated!
 
1 - 2 of 2 Posts
Top