So a while back driving on the very well maintained and vehicle friendly streets of Norfolk I hit a deep dip pretty hard that basically had see I needed to replace a few things in the front end. I overhauled basically everything in the front end. From struts, Lower and Uppers w/ Control Arms, new front hubs, and all of that. I still have a clicking sound while turning, I figure it’s the cheap CV axle the shop I went to used to replace it (NAPA). But I also have a thud/clunk sound after I put it into reverse or drive and roll about 6 feet. My transmission has no shaving or black fluid, my 4X4 works well still. But I’m trying to figure this out. If you can help me that would be super