DODGE RAM FORUM banner
1 - 3 of 3 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter · #1 ·
99 Ram 360cireplaced both wheel bearings, and both wheel joints the 3 days agoshaft seals are original just flipped 100,000 miles. they are now leaking, first thought I damaged pulling out or putting the axle shafts back in, or didn't clean tube well enough. drove for 2 days before they failed so I figure I did them correctly or they would have blown as soon as I pulled off.anyway how difficult of a task is this, should I buy the parts for $30, or let somebody bust my wallet at the shop. Thanks!
 

·
Registered
Joined
·
22 Posts
Discussion Starter · #3 ·
dana 44 axle shaft seal replacement

99 ram with 360, replaced both wheel joints, both wheel bearings drove for 2 days. now the seals are leaking. I don't believe I damaged them diff level was good after I did the work, and did not leak for the first 2 days. they are the original seals and I have just turned 100,000 miles a few months back. how hard of a job is it I have never done this job before. the parts are cheap, or should I let a shop bust my wallet
 

Attachments

1 - 3 of 3 Posts
Top