DODGE RAM FORUM banner
1 - 3 of 3 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter · #1 ·
On of my 1st mods was to replace my stock antenna with an aftermarket antenna that looked like an arrow. Last week I went to remove the antenna in order to get my truck washed. The threaded insert that connected the antenna to the antenna lead on the front fender snapped deep in the lead. I tried to drill out the broken insert but was unable to get it out with damage to the lead. I purchased a new lead, but can't figure out the best way to remove and replace the lead.

Has this happened to anyone else? any help would be greatly appreciated.:LOL:
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top