DODGE RAM FORUM banner
1 - 1 of 1 Posts

·
Registered
Joined
·
806 Posts
Well this is a possible idea. Use a small drill bit, say a 1/8 " to drill through the hump. Am guessing there is a space between the trany and the floor hump. You should be able to feel/tell when you have gone through the hump but not into the trany housing. From there you can figure how much room you have for the screws you want to use. Good luck you should be fine.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top