DODGE RAM FORUM banner

1 - 4 of 4 Posts

·
Registered
Joined
·
70 Posts
Discussion Starter · #1 ·
If a ecu is in limp mode will the check engine light be on? my truck has no balls and the mpg is shitty, the truck revs up at start and the the idle will stay high after pressing on the gas pedal while the truck is in neutral. ive replaced all tb sensors, plug wires, cap, rotor, plugs, air filter, oil, transmission filter, transmission fluid, and cat. Or would you say its the throttle body pan gasket?
 

·
Registered
Joined
·
1,280 Posts
Was check light on when you replaced sensor's? If so did you reset computer? Or disconnect bat when you did the work? They can still hold the code even after sensor was replaced. If none of this is the case and computer is clean look for vacuum leak.
 

·
Registered
Joined
·
1,280 Posts
Another place to look is iac or air temp sensor both of these will make it idle like crap.
 

·
Registered
Joined
·
70 Posts
Discussion Starter · #4 ·
thanks for your help! i found a vacuum leak and yes the check engine lights where on before and after replacement
 
1 - 4 of 4 Posts
Top