DODGE RAM FORUM banner
Cancel

Electrical connection under drivers seat

1892 Views 3 Replies 4 Participants Last post by  fisch442, 
chris0001
Does anyone know what all is connected to the plug under the drivers seat? I'm assuming it is for electric seat adjustment, (which I don't have). Had a brain storm and was thinking I could pull power for the floor lighting from this point???? Don't assume there would be a lead for the dome light down there....cuz that would be too easy?????(Or am I wrong). Please chime in as I am hoping to tackle the lighting this weekend. If all else fails I still have the A pillar on the drivers side.

Cheers!
Save Share
Reply Quote
1 - 4 of 4 Posts
brad12kx

· Registered
Joined
·
22,645 Posts
#2 ·
The wiring connector under the seat is for the seat belt sensors.
 
F

· Registered
Joined
·
5 Posts
#4 ·
I was going through the fuse box on my 02 QC and seen a 20A fuse labled power seats, witch i do not have either so i would Assume you should have a good power source there.
Let me know if it works out, thinking of Putting an AC Inverter under there if it works out.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
DODGE RAM FORUM
We’re the ultimate Dodge RAM forum to talk about the RAM 1500, 2500 and 3500 including the Cummins powered models.
Full Forum Listing
Explore Our Forums
LD RAM - General Discussion 2014 Dodge Ram Forum 2013 Dodge Ram Forum Performance Mods - Engine - 5.7 Hemi V8 2012 Dodge Ram Forum
Top