DODGE RAM FORUM banner

1 - 6 of 6 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
Whats up guys, I just recently bought a 05 Dodge Ram 1500 with that 3.7 v6 in it. I have been a Ford man all of my life and sine I jumped over to Dodges I don't know much about where to find parts and stuff like that. I really want to get a nice loud exhaust system for my Dodge but i can not find them anywhere. If anybody knows where to find them please let me know. I don't want to really spend more than 600 on the system.
 

·
Registered
Joined
·
95 Posts
Get a magnaflow y-pipe and 14" magnaflow muffler and have a shop cut out/remove the factory parts and replace w/ the magnaflow. I suggest getting the tailpipe dumped past the rear axle so it doesn't drone.
 

·
Registered
Joined
·
3 Posts
YO!
Edelbrock makes nice set of "shorty headers"
I put them on my '97 Ram 360.
I believe that when I was searching their stock,
they had headers for the V6.......Hey, worth a shot and
not too expensive!
I thinks it's edelbrock.com...
 

·
Banned
Joined
·
3,844 Posts
YO!
Edelbrock makes nice set of "shorty headers"
I put them on my '97 Ram 360.
I believe that when I was searching their stock,
they had headers for the V6.......Hey, worth a shot and
not too expensive!
I thinks it's edelbrock.com...
JBA makes shorties that will fit these, BUT they're over $600 a set last I looked.
 

·
Registered
Joined
·
95 Posts
Airram used to have a good price on the headers, I think it was $400 for the stainless and more for coated. You should get coated if you do them at all, but after doing them on my truck I don't think they're really worth the money and time on the v6 unless your gonna do cams and tune it.
 
1 - 6 of 6 Posts
About this Discussion
5 Replies
4 Participants
chambers
DODGE RAM FORUM
We’re the ultimate Dodge RAM forum to talk about the RAM 1500, 2500 and 3500 including the Cummins powered models.
Full Forum Listing
Top