DODGE RAM FORUM banner

1 - 6 of 6 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1 (Edited)
I was curious if anyone here has a gauge pod with extra gauges in a 03 and new ram.
I'd like to know how much boost the turbo is putting out, and the trans temp. stuff like that.


anyone know where I would find them?

I found one on BMC's website, but I have a driver assist handle on the A-Pillar
 

·
Registered
Joined
·
22 Posts
A pillar mounting is common, but there are other locations as mentioned. The a pillar trim with the grab handle is removed and the new piece with the pods replaces it. There are a few that keep the handle nut usually only holds one round gauge or a digital display. I heard some good things about the glow shift. Look around many choices for gauges and mounting. I think Isspro Performax gauges allow for easy installs and upgradeable to 17 gauges. it uses an electrical signal box. But you cant beat real gauges.
 

·
Registered
Joined
·
1 Posts
OK so I just got a smokin deal on a 2008 Ram 2500 with the Diesel and would really like a transmission temp gauge and maybe a boost gauge.

For those of you that went the Glow Shift Pod route how difficult was the installation? The glow shift instructions say to remove the factory temp sending unit that works with the dummy light. Is this OK?

This website is great, lots of information here.

Thanks in advance!
 

·
Registered
Joined
·
7 Posts
Hey guys. if ur looking for gauges and a good place to put them with out putting them on the a piller. Go to genos.com they have one that go's above ur rear view. my whole kit costed 250. trans pyro and tranny temp. Genos takes care of you always.
 
1 - 6 of 6 Posts
Top