DODGE RAM FORUM banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I crunched my front bumper and I think I bent the bumper mounting plates that are welded to the frame. They look fine but appear to be slightly angled in the direction that the bumper was crunched. Before I mount a new bumper, I need to know the distance measurements of the plate mounting holes to determine if the plates are bent. Where can I find these measurements? I have a 2008 Ram 1500 Big Horn.
Also is there a place that I can buy the full bumper assembly that matches the color of my truck. Then I only need to manage the eight bolts that bolt to the frame and not have to unscrew the colored upper part to the body shop to be painted.
Thanks
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top