DODGE RAM FORUM banner

1 - 2 of 2 Posts

·
Registered
Joined
·
154 Posts
Discussion Starter #1 (Edited)
If you are going to replace your heater core yourself like i recently did you should know that it can be done without draining the A/C system or removing the front seats. Before i replaced mine i read up on it everywhere trying to figure out how to do it and everyone said it was an 8 to 10 hour job and most mechanics charge an arm and a leg for it. I replaced mine in about 6.5 hours total and without draining the A/C. If your not afraid to take a dremel to your air plenum all you have to do is cut the lid just to your right of the heater core otherwise you would have to drain the A/C remove the whole air plenum just to get the lid off. Sorry i dont have more details and pics but im sure if your willing to take on the job you can just wing it like i did. Here is a pic just to help u realize the amount of disassembly though it wasnt completely disassembled when i took the pic.
I hope this saves someone some time and money if you have any question i will try to help the best i can. heater core.jpg
 

·
Registered
Joined
·
21,490 Posts
If it were me , and while I'm in there doing the heater core , I would go ahead and replace the evaporator also . I've done the core in my Ram , now I have to pull it apart again to do the evaporator .
 
1 - 2 of 2 Posts
Top