DODGE RAM FORUM banner

Installed XS Battery fro Sub Amp power

1082 9



Added inline fuse between battery and amp.
Used all RF 4 Gauge all copper power , and 0 gauge ground.
Installed battery inside center seat console.
Prior to XS Battery, lights would dim severely, and Amp would sometimes go into Voltage protection when the power dropped below 12 volts. Bass was hitting hard, but on deep long bass notes, amp shut off for a couple of seconds.
With XS Battery, Lights do not dim at all, Amp does not cut off at all, have ability to turn RF Bass Remote knob to 100% and head unit volume to 30 without any clipping or distortion. Bass is very hard and deep now, Plastic overhead trim that houses roof lights now looks like it is gonna shake off the headliner in the truck. Mirrors are now useless when bass hits.
1 - 2 of 2 Posts

· Registered
Joined
·
354 Posts
Wow nice setup! Ive got some questions and excuse my ignorance. Im going to update my stereo and want to get a new Pioneer head unit, 6x9's in the front doors, 6.5's in the rear doors, 3.5's in the dash and single 12 inch sub. My first question is if you have a 4 channel amp with 7 speakers what do the other 3 speakers run off? My second question is if i have a amp that runs 250 W RMS X 2 @ 2 OHMS should i bridge it to a 4 OHM 750 W RMS sub? Thanks for any help!
 

· Registered
Joined
·
354 Posts
Haha ya i was reading my post before i read the reply and was wondering why the hell i wrote that... my bad. Hijack attempt over ;)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top