leveling kit

1207 Views 3 Replies 4 Participants Last post by Big Green V10, Jul 19, 2012

dandk1989

Discussion Starter · Mar 2, 2012

Looking to install 2in in leveling coil spacer on my 2500 Cummins. Is there any way to do this from under the truck rather than thru engine compartment. The latter would require removing the brake master cylinder first before pulling the shock up.(at least thats what all the instructions say to do).
Don't want to get involved with brake hydraulics if I could.

Thanks for any advice.

Save

1 - 1 of 4 Posts

Big Green V10

· #4 · Jul 19, 2012

I did it on my 2001 Diesel and never removed anything brake related. I have done many of these and never heard that before. The spring either needs compressed or pressure taken off. Once you loosen the shock it can come out where the spring is. Only thing under the hood needed is one back nut that can be done from underneath but easier under hood.

Save

1 - 1 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month