DODGE RAM FORUM banner

1 - 3 of 3 Posts

·
Registered
2013 Ram 2500 4x4 5.7 Hemi
Joined
·
16 Posts
Discussion Starter #1
I'm wondering what are parts that I should replace/clean/do
135682
while I have the heads, timing cover, oil pan, etc. off of my engine while I'm replacing the camshaft and lifters with a stage .5 HL V2 thump with RPM series spring upgrade cam kit from Greene Racing that comes with the camshaft, PAC 1211X springs, spring seats, steel retainers, spring shims, cam phaser limiter kit, hardened push rods and I ordered a set of Comp Cams "better than hellcat" lifters. My 5.7 hemi 2013 ram 2500 4x4 is at 130,000 miles Screenshot_20201220-074943_Photos.jpg
135685
135686
135687
135688
135689
135690
135693
135694
135695
 

·
Super Moderator
Joined
·
34,745 Posts
So the roller was just completely gone? I've never seen that before. Looks like you're replacing everything that you need to, but I would check the cam bearings and oil pickup too
 

·
Registered
2013 Ram 2500 4x4 5.7 Hemi
Joined
·
16 Posts
Discussion Starter #3
So the roller was just completely gone? I've never seen that before. Looks like you're replacing everything that you need to, but I would check the cam bearings and oil pickup too
Yes it was gone I found all the pieces in the oil pan. 10-4 ill check those out thank you.
 
1 - 3 of 3 Posts
Top