DODGE RAM FORUM banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hey guys Inferno hemi here,

I recently purchased a 40 inch curved light bar to put in my lower bumper. I do not have tow hooks so I have roughly 2-3 inches on either side. I can't however find any brackets to buy. I was thinking about using the brackets it comes with. But i want to make it sit at least halfway flush in the bumper. If y'all have any ideas or have does this before please let me know. Thanks! :i_rolleyes:
 

·
Registered
Joined
·
2,689 Posts
I know Rigid makes a set, not sure if they will fit a 40 inch bar, you may have to find a welder to fab you some.
 
1 - 3 of 3 Posts
Top