DODGE RAM FORUM banner
1 - 2 of 2 Posts

·
Registered
Joined
·
628 Posts
Discussion Starter · #1 ·
I did some WOT data logging with my Intune this morning and I noticed when I went throught the readings on data viewer that my blade position was never over 80% during my WOT runs. Has anyone else done this, Im wondering if Im either not inturpriting the info correctly or have an issue with my TB . Also wondering if these motors have a delay on blade position were 70-80% is wide open and the the last 20% kicks in if needed.
 

·
Registered
Joined
·
13,697 Posts
I know on the older hemi when the pedal is at WOT the TB is not at WOT. Not sure why they designed it this way, but I'd assume the new hemi and new 4.7L(also fly by wire) are all the same way. You could pick up some power if you could modify this somehow...
 
1 - 2 of 2 Posts
Top