DODGE RAM FORUM banner
1 - 3 of 3 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
Hey, my Ram recently made a Horrid "Scettering" noise... i figured i dropped a valve because cyl 8 has had a bad miss for some time... yadda yadda yadda.... any ways! i finally had time to check into it.... and realize that the "innerds" of my distributor have been push up trough the cap lololol, i figure the gear on the bottom went? any ideas? and as always.. thank you for any thoughts and assistance... :) (02 Ram 2500 360ci):158:
 

·
Some Assembly Required
Joined
·
7,205 Posts
Easiest way to tell is to pull the distributor. I would be weary of trying to start it anymore. If it is broken and that cam moves...well...you can picture it in your head.
 

·
Registered
Joined
·
22,788 Posts
I agree completely with ArmyofOne on this. This is good time to leave it off until the distributor is fixed/replaced.
 
1 - 3 of 3 Posts
Top