DODGE RAM FORUM banner
1 - 20 of 25 Posts

·
Registered
Joined
·
2,952 Posts
Lt's or Shorties?!?! Yo quero!
 

·
Registered
Joined
·
2,952 Posts
Was the install difficult? Did you torque the bolts and did the stock gasket come off the manifold easily? Looking to buy these soon
 

·
Registered
Joined
·
171 Posts
Discussion Starter · #11 · (Edited)
Install was pretty easy hardest part was putting the bolts in the headers. As the pipes run over themselves. My truck only had 30000 miles on it when i put them on so i reused the stock gasket because they were metal and the supplied gaskets were paper. If your gaskets are shot i would get some stock ones from a dealer or try to find metal ones they hold better than a paper gasket. On the car i had before i replaced 4 sets of paper gaskets on the headers before i got the metal one after that never had to touch a bolt on them again.
 

·
Registered
Joined
·
2,952 Posts
hmm, where did you find them at
 

·
Registered
Joined
·
171 Posts
Discussion Starter · #14 ·
a 3/8 and a 9/16 racheting wrench are a great tools to have for this install. If i would have reminbered we had a set at the garage it would have cut down my time....haha i didn't remember until two days later when i went over all the bolts to do the final tightening of the collector and header bolts.
 

·
Registered
Joined
·
2,952 Posts
lol hmm do we need programmers to run headers?
 

·
Registered
Joined
·
2,952 Posts
Very noticeable?? Hmm
 

·
Registered
Joined
·
2,952 Posts
LOL I know exactly what you mean. What made you choose headman?
 
1 - 20 of 25 Posts
Top