DODGE RAM FORUM banner

Need exhaust help please

2269 Views 18 Replies 9 Participants Last post by  gixxer160
I'm going to order my exhaust in the next day and I thought that I knew what I wanted until I heard a couple different set ups now I'm stuck and need input before I waste my money. I wanted the mufflex 18 then I heard the borla xr1. I've listened to many exhaust clip of both and still don't know which one, after doing more research I've read about drone and I do not want drone as this is my dd and family vehicle. What I do want is a nice deep rumble/tone during start up and cruising but also want it to be louder during wot but not annoying and need very little to no drone during highway trips. I like the bolt on idea but read about some poor fitting pipes and leaks with mufflex and I don't like the fact that the xr1 is a Si/so that I have to chop the factory setup to install. I know it's a lot but any help will get me one step close to pulling the trigger on my exhaust. Thanks Mike
1 - 4 of 19 Posts
with my 22" setup i removed the resonator, no drone whatsoever...

See less See more
fuel pump replacement..my truck is droppd so it was easier to lift it up vs dropping the tank..
and it gave me the opportunity to clean the frame an stuff...
Are you leaving the resonator on? When there is a family involved, I would do a 22" (5x11) if you remove the resonator and an 18" with the resonator still on... the loudness won't be the issue as much as the drone at 2k rpms..it will drive you nuts..
1 - 4 of 19 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top