Need Help - Recon head lights

687 Views 3 Replies 3 Participants Last post by  moparornocar72
hey i'm lost right now, admittedly i am pretty green when it comes to doing much with electrical wiring and stuff so bare with me... ok so i got some Recon lights for an early xmas present to myself and had no problems installing the 3rd brake light and tail lights but the headlights have me really lost.. instructions are horrible. ok so where im lost is the LED lights around the edge have loose wires and so does the halo ring, also have resistor to wire in... question 1 is do i need to pair the positive wires from LEDs and halo rings and put in one hole of quick connector and resistor in the other hole or wire resistor and LEDS only in one hole and halo ring in other hole? and when i do figure out that end, what do i do when i remove old headlights? do i need to cut some wires that are there already and splice into?
1 - 1 of 4 Posts
u need to pair all of the positives together and negatives together then tap the ground to the ground and the middle wire on the parking lights is the one u will need to tap into. if u have the led for the turn/parking light then yes u will need the resistor
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.