DODGE RAM FORUM banner

1 - 3 of 3 Posts

·
Registered
Joined
·
51 Posts
Discussion Starter · #1 ·
:smiledown:

I just installed a new CAI for my '06 1500 4.7l and noticed that a sensor they had me unplug from the factory housing (pictured below) didn't have anywhere obvious to plug into on the new intake.


I called them and they said it's a temperature sensor, and to just connect it to a premade hole in the piping. So I connected it the only way it made sense and now the Check Engine Light is coming on.


Am I plugging it in wrong? Is there something else going on here? :4-dontknow:












 

·
Registered
Joined
·
51 Posts
Discussion Starter · #2 ·
btw, the rubber nipple that sticks out in the last picture came plugged. Soo.... don't know if the sensor needs to read the air and I should pop a hole in it? Or if it's supposed to be that way.
 

·
Registered
Joined
·
29 Posts
Thats your MAF. Where you plug it into the CAI shouldn't be plugged. On my Volant CAI it plugged right into a hole in the tube. Clear out the plug and put it in there, that should take care of the Check Engine Light.
 
1 - 3 of 3 Posts
Top