DODGE RAM FORUM banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I'm trying to track down the reason for low airflow/no heat on the driver side of my 2017 Dodge Ram 2500. When I test the driver side with AlfaOBD the Target Position agrees with the Actual position. When I test the passenger side, and with the Target Position set at 100, the actual position never goes above 5.00. The problem is with the driver's side but the scan shows that there's an issue with the passenger side. When I test the actuators they all cycle through their full travel. I've reset just about everything including disconnecting the batteries completely but still have the issue. I'm starting to think it's an issue with the HVAC Control Module itself.

Any input would be appreciated...

Product Rectangle Font Red Slope
 
1 - 1 of 1 Posts
Top