DODGE RAM FORUM banner
Cancel

Port match BBK header gaskets

719 Views 2 Replies 3 Participants Last post by  moparornocar72, 
JackDaniel
Anyone whose done the BBK headers, and didnt use the ones provided from bbk did yall port match your OEM gaskets? The holes are a lot smaller than the new ports on the header. Just curious
Reply
Save
Like
1 - 3 of 3 Posts
05ram
Nope, just installed as is. I wouldn't want to try to take material off the oe ones, they are a dual layer gasket, it may start coming apart.
Reply
Save
Like
moparornocar72
I agree could tear up the gasket or it might compromise it's rigidity later down the road!
Reply
Save
Like
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
DODGE RAM FORUM
We’re the ultimate Dodge RAM forum to talk about the RAM 1500, 2500 and 3500 including the Cummins powered models.
Full Forum Listing
Explore Our Forums
LD RAM - General Discussion 2014 Dodge Ram Forum 2013 Dodge Ram Forum Performance Mods - Engine - 5.7 Hemi V8 2012 Dodge Ram Forum
Top