DODGE RAM FORUM banner
1 - 2 of 2 Posts

·
Registered
Joined
·
147 Posts
I am in the same boat my actuator is not fully sealing in recirc mode causing a wind noise. Haven't had time to give a good look at how much has to come out but from what I saw when I diagnosed the noise it wasn't pretty. Its getting hot around here so I will have to make time to fix it soon. Hopefully in the mean time someone who has had the dash a part can chime in on how much has to come out to access it.

Only diagram I found in my limited search
http://www.trademotion.com/parts/2012/RAM/1500/SLT/?siteid=213975&vehicleid=1502251&diagram=TM09100
 

·
Registered
Joined
·
147 Posts
the 2009 - 2012 dash boards are the same
so are the climate control functions

empty your glove compartments
push in the sides of lower glove box & gently remove it
then look under the upper glove box & you will see a screw
remove the screw & do whatever you have to do to disconnect the USB cable
then remove the upper glove box

then look at the center console & follow this video to remove the console
then you will be looking at almost every part of the Climate Control System

http://www.youtube.com/watch?v=aBE6AbNu86k

http://www.youtube.com/watch?v=nYa4pFjZSts
Unfortunately I don't think that will access the recirc or air inlet for the hvac its on the top right looks like it has to be accessed from above but hopefully I'm wrong.

 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top