DODGE RAM FORUM banner

1 - 7 of 7 Posts

·
Registered
Joined
·
220 Posts
Discussion Starter · #1 ·
Ok folks, anyone know how to remove the dash mounted cup holder from this S.O.B? I've undone all the screws but can't get it out. I don't have access to my haines manual right now - so what am I missing?

Help!!!!
 

·
Registered
Joined
·
220 Posts
Discussion Starter · #3 ·
If your dash is the same as mine , I've had mine out several times . Don't recall it being an issue with removal or installation .
It's ok Tom.....it had been a long three days of 14hr days puling stuff apart - I was tired, frustrated and apparently.....dumb as a bag of hammers lol

All I had to do was (instead of tugging wildly at the 'hold the cups part') pull the top part, where it rests on pins at the front of the dash, off of the little pins and VOILA.....it came straight out lol

Amazing what a difference a night's rest and fresh eyes make to the frustrating jobs!!!!
 

·
Registered
Joined
·
6,640 Posts
:LOL: Dude dont feel bad.................I/we have been there lots of times im sure.:LOL:
 

·
Registered
Joined
·
2 Posts
I hope you respond to this.
When you removed the cup holder from the pins you talk about, did you have to loosen the dash or remove it?
Or, did you just apply slight pressure outward to get the tabs off the pins while the dash remained in original position?
 

·
Banned
Joined
·
7,866 Posts
Are you asking about removing the whole thing? Take out the 2 phillipps screws and the whole thing should come out and you'll see the tabs for future reference.
 
1 - 7 of 7 Posts
Top