DODGE RAM FORUM banner

1 - 1 of 1 Posts

·
Registered
Joined
·
469 Posts
Discussion Starter #1
Anyone else swapped tailgates and run into a snag when it came time to swap over their tailgate assist? If you are carefull, you can remove the insert and reuse it but more than likely, you will damage it beyond use and require a new one.

I managed to track down the part number for the insert and purchase a new one...or ten. Unfortunately they only come in packs of 10 so I have a few spares if anyone is interested. Just cover postage.

Mcmaster Carr part number is 97217A444
Proper term is a Rivet Nut for plastics.

Zinc/Yellow Pltd Steel Rivet Nut for Plastics M6 X 1 Internal Thread, 0.50-7.10mm Material Thk
http://www.mcmaster.com/#97217A444
 
1 - 1 of 1 Posts
Top