DODGE RAM FORUM banner

Small gap between TBS and Manifold?

421 Views 2 Replies 2 Participants Last post by  bigkurt7290
Got a TBS installed and I went under the hood to check it out, and theres a small gap on one side of the spacer, between it and the manifold. Driving it I did hear the whistle between 2000-2500, and didn't notice anything other than that. Is this something I should be wary of? Or will the O-Ring seal it off just fine
1 - 1 of 1 Posts

· Registered
Joined
·
3,660 Posts
our hemi's supposedly don't respond well to Throttle body Spacers like some other vehicles, most people around here use them to tap for nitrous. If there is a gap and it's leaking u have a problem as u might be losing air from the intake
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top