DODGE RAM FORUM banner

1 - 2 of 2 Posts

·
Registered
Joined
·
63 Posts
Discussion Starter · #1 ·
I was looking for some ideas on mounting my diamond plate truck box in the bed without drilling holes. I tried to use my quick mounts that I had on my chevy but the ram does not have a rolled lip inside of the bedrail. My brother suggested using a shackle set up which bolts to the box then down to the factory tiedowns. just turn the turnbuckles until tight.
Any other suggestions out there?
 

·
Premium Member
Joined
·
32,782 Posts
I bit the bullet

My full size toolboxes needed to be secured
They are below the rails, so that i could use a tonneax
I drilled 8 holes for 3/8s bolts
I have the Line-X spray in liner
when i sell my Ram, i will have Line-X do a patch repair & no one will ever know the holes were there

[/URL]
[/URL]
[/URL]
[/URL]
[/URL]
 
1 - 2 of 2 Posts
Top