DODGE RAM FORUM banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I am brand new to adding exhaust. I was told to try for either Magnaflow and Flowmaster. I looked up quite a few vids today and came to like the magnaflow.

Anyways I am trying to figure out which one is the best to get and how best to install it. The current muffler on it is 30 inches long, round body, center 3in inlet, offset outlet.

Here are the ones that I have found.

Center/Dual http://www.magnaflow.com/02product/shopexd.asp?zone=main&id=11037

Offset/Offset different sides http://www.magnaflow.com/02product/shopexd.asp?zone=main&id=11034

Center/Center http://www.magnaflow.com/02product/shopexd.asp?zone=main&id=11028


Also what would be the difference in sound be between putting a turndown right at the outlet of the exhaust before the axle or having it come out with a normal tip as it is now?
 

·
Registered
Joined
·
28 Posts
I have magnaflow on my truck and it sounds great, although I have a hemi. Not sure what a V6 will sound like with magnaflow, or flowmaster.

Good luck.
 

·
Registered
Joined
·
26 Posts
I think I'm gonna go with a flowmaster super 10, it'll be a lot louder than the magnaflow though haha. I'll probably do side exit on front of the rear passenger tire, or both sides, I'm not sure yet. I was thinking I'd get a torch and cut the pipe off at the front of the stock muffler and back, then weld on the new muffler and new piping out the side.
 
1 - 3 of 3 Posts
Top