DODGE RAM FORUM banner
1 - 8 of 8 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
Hey guys im brand new to the forum and I needed some advice for my truck. Besides for a k&n air filter and a shift kit in the slush box I call a tranny, its stock, and running 3.50 gears doesnt help. After alot of digging ive found a few performance parts for my truck including Crower cams and an SCT tuner by hemifever. Now if I replaced my gears to 4.10's and got those parts listed and a FIPK from k&n, how do you guys think the truck would respond??? Any advice would be greatly appreciated...:Hey:
 

·
Registered
Joined
·
47 Posts
wish I could answer your question, but i'm in the same boat myself.

a few years ago I found a supercharger for the V10, but I don't know how well it worked. maybe not well since I haven't seen one in a while. :(
 

·
Registered
Joined
·
35,470 Posts
Hey keep us updated and let us know how you make out......
 

·
Banned
Joined
·
437 Posts
Do the 4.10 gears first and then decide if you need more. My V10 with 4.10s, the K&N CAI, Borla SS headers and Edelbrock muffler was all the power I needed.
 

·
Registered
Joined
·
2 Posts
x2 on the gears. I went from 3.55 to 4.56, world of difference, much quicker and tows effortlessly. I'm running 35" tires, which is similar to 4.10 with 33" tires.
 

·
Registered
Joined
·
19 Posts
I have 4.10's with elec fans, open air box and no other mods, it runs like a champ!!! I can't imagine where this motor would lack power?
 

·
Registered
Joined
·
6 Posts
My old man got this truck back in November of 99...it came with 4.10 and after years of playing around with it stock I decided to lift it up, put a locker in the front, and 37" Iroks for playtime. Let me tell you getting that locker installed during my 1st deployment was well worth it. Had to pull the motor this year though bc the old man sucked some water last year at the mud bogs. Bc we were unsure of the damage we pulled the motor, only had a couple warped valves. Figured since I had it out it was time for a Crower cam n a tb. Should have the motor dropped back in Sunday and on the dyno next week so Sean from hemifeaver can get me a good tune. I will give an update when she is all done, if anyone is still fallowing this.
 

·
Registered
Joined
·
11 Posts
Discussion Starter · #8 ·
Thanks man that would be cool if you could get that data on the crower cam. Which one are you gonna get and are you repacing your roller lifters too???
 
1 - 8 of 8 Posts
Top