DODGE RAM FORUM banner
1 - 4 of 4 Posts

·
Banned
Joined
·
1,446 Posts
Discussion Starter · #1 ·
I am thinking about putting 3M clear film protectant on the rocker panels and the front of my 2010 Sport. I assume that the existing wax/sealant needs to be stripped off before installation, however I have a couple of questions. After the protectant is installed how much of the "shine" do you lose? Can you or should you use sealant/wax on the clear film? And if you do what are the results? Can you readily see the protectant or is it almost invisible? It seems to be almost the only way to prevent rock chips, at least on the frontend.
Thanks,
Jay
 

·
Banned
Joined
·
1,446 Posts
Discussion Starter · #2 ·
After 3 days and over 50 views, no one has a clue?????? Come on guys--someone is bound to have had some experience with this stuff--I've read the 3M site, but they are selling the stuff and aren't going to tell you any negatives about it, if there are any.
Jay
 

·
Registered
Joined
·
12,860 Posts

·
Registered
Joined
·
71 Posts
Im not sure if i have the same product your talking about but i had brought some 3-M clear tape protectant that is used for aircraft and tried it on a vehical and the only downside is that it yellows after a while but it does work good.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top