Wax/Sealant and 3M clear film protectant

1185 Views 3 Replies 3 Participants Last post by Cheatham, Jan 28, 2012

Pull Ya

Discussion Starter · Jan 3, 2012

I am thinking about putting 3M clear film protectant on the rocker panels and the front of my 2010 Sport. I assume that the existing wax/sealant needs to be stripped off before installation, however I have a couple of questions. After the protectant is installed how much of the "shine" do you lose? Can you or should you use sealant/wax on the clear film? And if you do what are the results? Can you readily see the protectant or is it almost invisible? It seems to be almost the only way to prevent rock chips, at least on the frontend.
Thanks,
Jay

Save

1 - 2 of 4 Posts

Pull Ya

Discussion Starter · #2 · Jan 6, 2012

After 3 days and over 50 views, no one has a clue?????? Come on guys--someone is bound to have had some experience with this stuff--I've read the 3M site, but they are selling the stuff and aren't going to tell you any negatives about it, if there are any.
Jay

Save

1 - 2 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month