[07HemiRam]

My check engine light came on today and when I hooked up my superchips tuner to read the codes I got a B2215 (FCM Internal) and a P0441 (EVAP purge system performance). What do these mean? Should I be worried? I cleared the codes and so far hasn't came up again. Any help would be awesome!

 

[Evil Ram]

Looks like B2215 is a service reflash for TIPM


Code P0441 could mean one or more of the following has happened:

Bad vacuum switch
Broken or damaged EVAP line or canister
Open in PCM purge command circuit
Open or short in Voltage feed circuit to Purge Solenoid
Faulty purge solenoid
Restriction in EVAP solenoid, line or canister
Corrosion or resistance in purge connector
Bad PCM






Hope this Helps you

 

[chefred112]

if the fcm (fusebox) was going bad your dash would be acting funny..like this..

 

[bighemi04]

i get the EVAP code once in a while. tightening the gas cap and unhooking the battery usually takes care of it. or to run a system check you can; while you are turning your key to the on position hold your odometer trip reset and it will run a self diagnostic

 

[07HemiRam]

Thanks for your help guys! Checked again today and didn't have the P0441 anymore but the B2215 is showing up again...any suggestions??? Also getting these codes:
B1630- Right Low beam control circuit high
B1638- Right Hi-beam control circuit high
B162F- Right low-beam control circuit low

My lights are working fine I just want to get these codes or issues fixed because knowing I have a code on my truck is driving me nuts!